SAAB WIS ONLINE

O-ring and sealing ring in seal retainer, left-hand

O-ring and sealing ring in seal retainer, left-hand

To remove


A condition for this is that the gearbox or left-hand drive shaft has been removed.


1. Undo the five screws on the seal retainer and remove the seal retainer. Keep shims, screws and the seal retainer in a safe place.

2. Press out the sealing ring with 87 91 311 Sleeve, bearings driver shaft and 87 92 236 Fitting speed gear, F35, support .

3. Detach the O-ring with a small screwdriver or similar.



To fit


1. Press on the sealing ring with 83 90 122 Drift until it lies against. Use 87 92 236 Fitting speed gear, F35, support as a support.


2. Lubricate a new O-ring and carefully fit it.


3. Lubricate the seal ring.

4. Fit the seal retainer and shims with the screws. Tighten alternately.


Tightening torque 22 Nm (16 lbf ft)