O-ring, drive shaft seal
| O-ring, drive shaft seal |
| 1. |
Remove the drive shaft on the left side respective drive shaft and intermediate shaft on the right side, according to 4. Drive shafts, Adjustment and replacement.
|
|
| 2. |
Remove the seal retainer.
|
|
| 3. |
Change O-ring.
|
|
| In-car fitting |
| 1. |
Fit the seal retainer.
Tightening torque: 22 Nm (16 lbf ft) |
|
| 2. |
Fit the drive shafts according to 4. Drive shafts, Adjustment and replacement.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
