Seal ring and seal retainer - right, petrol
Seal ring and seal retainer - right, petrol |
To remove (gearbox out of car) |
1. |
Remove the seal retainer.
|
2. |
Press out the sealing ring with
87 91 311 Sleeve, bearings driver shaft
and
87 92 236 Fitting speed gear, F35, support
.
|
To fit |
1. |
Press on the sealing ring until it lies against using
87 90 859 Press sleeve
,
83 90 312 Drift, bearing race, input shaft
and
87 92 236 Fitting speed gear, support
. Lubricate the sealing ring and fit a new O-ring.
|
2. |
Fit the seal retainer with the four screws. Make sure the O-ring is in place. Tighten alternately.
|
Tightening torque 22 Nm (16 lbf ft)