Seal ring - selector rod, removed gearbox
Seal ring - selector rod, removed gearbox |
To remove |
1. |
Prise out the seal using a narrow screwdriver.
|
To fit |
1. |
Clean the selector rod and check that it has no burrs.
|
2. |
Wind a layer of thin, smooth plastic tape around the hole in the selector rod.
|
3. |
Remove the tape and tap in the seal using
87 90 685 Fitting tool, sealing ring selector shaft
and
87 91 709 Clamp
. Tap only until the seal is level with the clutch housing.
|