Wheel sensor, front right
|
|
Wheel sensor, front right
|
|
1.
|
Remove the top part of the air cleaner and, if necessary, the mass air flow sensor, and move it aside.
|
|
2.
|
Remove the connector's cable tie.
|
|
3.
|
Separate the connector and snip the cable tie.
|
|
4.
|
Snip the cable tie by the air cleaner attachment point.
|
|
5.
|
Raise the car and remove the wheel.
|
|
6.
|
Clean the area round the wheel sensor using a soft wire brush.
|
|
7.
|
Undo the wheel sensor retaining bolt and remove the wheel sensor.
|
|
8.
|
Remove the grommet and withdraw the lead.
|
|
9.
|
Detach the lead from the clips and lift out the sensor.
|
|
1.
|
Insert the lead and press the connector home.
|
|
2.
|
Fit the wheel sensor in its holder and tighten the retaining bolt.
|
|
3.
|
Smear the rubber grommet with a soap solution and fit it in lace.
|
|
4.
|
Press the lead into the retaining clips.
|
|
5.
|
Fit the wheel. See
Wheels
.
Tightening torque 110 Nm (81 lbf ft)
|
|
6.
|
Plug in the connector.
|
|
7.
|
Fit a new cable tie to the air cleaner's attachment point.
|
|
8.
|
Refit the top part of the air cleaner and, if removed earlier, the mass air flow sensor.
|
