Brake disc, rear wheel
Brake disc, rear wheel |
1. |
Make sure the handbrake is not applied.
|
2. |
Raise the car and remove the wheel.
|
3. |
Press the brake piston back using a pair of slip-joint pliers.
|
4. |
Remove the two brake caliper retaining bolts. Detach the brake pipe from the clip. Take care not to damage the brake pipe when detaching it.
|
5. |
Suspend the brake caliper with a cable tie on the left-hand side using a welding clamp secured to the silencer.
|
6. |
If necessary, slacken the handbrake adjuster.
|
7. |
Remove the brake disc retaining bolts and take off the brake disc.
|
To fit |
1. |
Clean the new brake disc from oil and dirt.
|
2. |
Place the brake disc on the hub and tighten the brake disc locking screw using threadlock.
Tightening torque 10 Nm (7 lbf ft) |
3. |
Adjust the handbrake. See
Adjusting handbrake shoes
.
|
4. |
Fit the brake caliper, apply threadlock (Loctite 242, part number 74 96 268) to the two retaining bolts and tighten with torque wrench.
Tightening torque 80 Nm (59 lbf ft) |
5. |
Remove the welding clamp and cable tie.
|
6. |
Fit the wheel. See
Wheels
.
Tightening torque 110 Nm (81 lbf ft) |
7. |
Lower the car and depress the brake pedal to force out the brake pistons.
|
8. |
Check and if necessary adjust the handbrake. See
Adjusting handbrake shoes
.
|
9. |
Check the brake fluid level. Test drive the car and check the function of the brakes.
|