High-level brake light
High-level brake light |
1. |
Remove the strip above the rear window (inside the car).
|
2. |
Remove the two rubber plugs.
|
3. |
Unscrew the nuts holding the brake light.
|
4. |
Separate the connector.
|
5. |
Press the cover down.
|
6. |
Use a plastic spatula (or a screwdriver covered with tape) on the right of the rear window washer nozzle and carefully prise up the brake light.
|
7. |
Repeat this operation on the left side.
|
8. |
Lift up the lamp and put out the electrical lead.
|
9. |
Replace the unit.
|
To fit |
1. |
Put the electrical lead back again and put the lamp unit back.
|
2. |
Take the lead out on the inside of the cover.
|
3. |
Fit the brake light unit in position.
|
4. |
Fit the lamp holder.
|
5. |
Lift the cover.
|
6. |
Tighten the nuts that hold the brake light.
|
7. |
Put back the two rubber plugs.
|
8. |
Put the strip back again above the rear window (inside the car).
|