|
Function
|
Factory setting
|
Alternative
|
Description
|
Indoor Temperature Increase
|
0.0˚C
|
-3.0 - 3.0˚C
|
The cabin temperature can be increased (or decreased) in relation to the set temperature. A higher value gives a higher cabin temperature.
|
Fan Delay
|
0 s
|
0-30 s
|
In case of risk for misting of the windscreen when starting, the control module can delay fan start until the evaporator temperature has dropped sufficiently to bind any moisture. Fan delay will be active at an outside temperature of 0-15˚C, 0-20˚C in the event of low solar intensity.
|
Sun Sensor
|
100
|
0-255
|
The value indicates how much the solar sensor affects the calculation of the temperature at head level in the front-seat. A higher value gives a greater influence.
|
ACC Will Start In Defrost Below This Ambient Temperature
|
6˚C
|
0-30˚C
|
Cold start. The value indicates for which conditions that the air distribution starts in the defrost position.
|
Fan Speed Response at New Temperature Setting
|
30
|
0-255
|
The value indicates how much the fan current is increased momentarily if the temperature setting is changed. A higher value gives a greater effect.
|
ECON Below This Ambient Temperature
|
10˚C
|
0-18˚C
|
Additional user programming. The outside temperature limit for ECON can be adjusted. The value indicates the outside temperature below which ECON is selected. ECON is switched off 3˚C above this temperature.
|
Parking Heater Temperature Control
|
AUTOMATIC
|
AUTOMATIC/100% HEAT
|
Parking Heater. 100% heat or automatic temperature control may be selected.
|
Parking Heater Fan Speed
|
6 A
|
5-10A
|
Parking Heater. The fan speed can be adjusted.
|
Parking Heater Defroster Duration
|
15 min
|
0-60 min
|
Parking Heater. The time selected by the control module for air distribution position defrost can be adjusted. When the time expires, defrost/floor is selected.
|
Latest Manual Selection At Ignition On
|
No
|
YES/NO
|
If YES is selected, the control module will always select the most recent manual setting when the ignition is turned on.
|
Temperature Defroster -> Defroster/Floor at Cold start
|
0˚C
|
-10˚C - +10˚C
|
Cold start. The coolant temperature at which the air distribution switches from defrost to defrost/floor can be changed in relation to the normal value of 45˚C. A higher value gives a later switch to defroster/floor.
|
