Fifth bow latch motor
Fifth bow latch motor |
Removing |
1. |
Run the soft top so that the fifth bow and the soft top cover are completely raised.
|
2. |
Remove the covering shell.
|
3. |
Connect the diagnostics tool and operate the fifth bow latch motor to half open position (soft top cover access flap is half open) using the command:
“STC” “Activate” “5th bow latch motor ” “Up” |
4. |
Protect the rear panels and the boot lid. Fit the protection under the soft top cover, the motor can easily fall onto the boot lid.
|
5. |
Remove the operating arms from the fifth bow latch motor.
|
6. |
Unplug the connector.
|
7. |
Remove the bolts securing the motor and hold one hand under the motor when the last bolt is removed. Lift away the motor.
|
Fitting |
1. |
Fit the latch motor and tighten the bolts. Respective collision cable end sleeves pointing at each other. Fit new cable ties.
Tightening torque, two upper bolts: 14 Nm (10.3 lbf ft) Two lower bolts: 7 Nm (5.2 lbf ft) |
2. |
Fit the operating arms to the motor.
|
3. |
Plug in the connector.
|
4. |
Run the soft top up and down a few times and check the function.
|
5. |
Refit the shell.
|
6. |
Adjust the latch function. See
.
|
7. |
Connect the diagnostics tool and erase any diagnostic trouble code.
|
8. |
Remove the protection and run the soft top to closed position and lock it against the windscreen frame.
|