SAAB WIS ONLINE

Door handle, rear doors

Door handle, rear doors


To remove


1. Lower the window.

2. Remove the door trim, see Service Manual 8:2 Interior equipment.

3. Remove the plastic water barrier.

Lift out the collision block to increase accessibility.

4. Remove the pull rod between the door handle and door lock from the door side and leave it suspended.


5. Remove the trim panel.

Note

First release at the rear edge.


6. Remove the internal seal moulding.

7. Remove the guide channel retainer screw.

8. Pull up the seal moulding from the guide channel.


9. Angle the guide channel up out of the window frame.

10. Raise the window.

11. Remove the retainer nut with plate from the rear of the door handle.

12. It may be necessary to remove the lock, 3 bolts.

13. Guide out the pull rod, between the outside door handle and lock, from the lock.

14. Angle out the door handle from the door.


To fit

Fit in reverse order.

Note

Lubricate the seal moulding with vaseline to facilitate fitting.




Important

Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged.