SAAB WIS ONLINE

Door lock, front door

Door lock, front door


To remove


1. Open the door (window must be raised).

2. Remove the door trim, see Service Manual 8:2 Interior equipment.

3. Remove the plastic water barrier.

4. Remove the pull rod between the door handle and the door lock from the lock.


5. Remove the lower section of the rear guide channel.

6. Remove the pull rod, between lock cylinder and lock, from the lock.

7. Remove the 3 retainer bolts that secure the door lock.

8. Remove the door lock with the internal lock assembly and central locking system motor.

9. Unplug the connector for the central locking system motor.

10. Remove the central locking system motor from the door lock, fastened with 2 screws.


To fit



1. Fit the door lock with the internal lock assembly and central locking system motor.

2. Plug in the connector for the central locking system motor.

3. Fit the lower section of the rear guide channel.

4. Press the pull rod onto the lock cylinder.

5. Press the pull rod onto the interior handle.

6. Check the door handle clearance against the lock. Adjust if needed, by adjusting up/down the opening rod adjusting screw until it is up against the lock opening lever.

Note

It must be possible to feel the clearance in the door handle, the lock opening lever must not be actuated in the resting position.


7. Fit the plastic water barrier.


Important

Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged.


8. Fit the door trim, see Service Manual 8:2 Interior equipment.