SAAB WIS ONLINE

Bumper, rear

Bumper, rear

Removing



1. Open the tailgate.

2. Remove the door sealing moulding at the lower edge.

3. Remove the 2 screws securing the load restraint eyelets and the 2 plastic nuts that secures the scuff plate.


4. Fold down the luggage compartment mat.

5. Remove the scuff plate by pulling it straight up, it is fastened with clips.

6. Remove the four nuts securing the bumper.


7. Remove the plastic moulding that secures the front corners of the bumper towards the wheel housings, fastened with two screws.

8. Remove the bumper by pulling it rearwards so that it clears the attachments.

Important

Work carefully when removing to avoid damaging the paintwork.



Fitting



1. Position the bumper and fit the 4 retaining nuts.

Tightening torque: 39 Nm (29 lbf ft).

2. Adjust the fit and tighten the retaining nuts.

3. Mount the plastic mouldings in the front of the bumper, above the wheel housing edges.

4. Refit the scuff plate by pressing on the retaining clips, refit the load restraining eyelets and plastic nuts.


5. Fold back the mat in the luggage compartment.

6. Refit the tailgate weatherstrip moulding.


7. Close the tailgate and check the bumper fit.