Door window rear guide rail, CV
|
|
Door window rear guide rail, CV
|
|
1.
|
Remove the door upholstery. See
To remove
.
|
|
2.
|
Fold down the water barrier.
|
|
3.
|
Raise the window completely.
|
|
4.
|
Remove the rubber plug from the bottom of the door end.
|
|
5.
|
Note the position and remove the rear guide rail adjusting screw.
|
|
6.
|
Remove the bolts securing the upper end of the guide rail.
|
|
7.
|
Carefully bend out the window and unhook the upper end of the guide rail from the door panel.
|
|
8.
|
Lift up the guide rail and pull it away from the plastic bushings at the rear edge of the window.
|
The window must be raised when work is started.
|
1.
|
Hold out the window slightly and fit the guide rail onto the plastic bushings. Hook the rail in the hole in the door panel.
|
|
2.
|
Tighten the bolts that secure the upper end of the guide rail.
|
|
3.
|
Tighten the adjusting screw at the guide rail lower end according to the marking.
|
|
6.
|
Refit the water barrier.
|
|
7.
|
Refit the door trim. See
To fit
.
|
