Heat exchanger
Heat exchanger |
1. |
Fit hose clamp pliers part. No. 30 07 739 on the hoses by the heat exchanger.
|
2. |
Remove the hoses from the heat exchanger.
|
3. |
Blow with compressed air in one pipe to drain remaining coolant from the heat exchanger.
|
4. |
Remove the ACC unit where fitted, see group 8 “ACC”.
|
5. |
Work through the following steps according to descriptions in 8:2 Interior.
|
• |
Remove the glove box.
|
• |
Remove the panels on both sides of the centre console.
|
• |
Remove the cover around the ignition.
|
• |
Remove the rear ashtray.
|
• |
Remove the rear air vents and the cover.
|
• |
Remove the bolts that secure the rear part of the centre console.
|
• |
Remove the switches for the window lifts.
|
• |
Remove the centre console.
|
6. |
Cut the cable ties and remove the rear floor air ducts in front of the heat exchanger.
|
7. |
Open the heat exchanger enclosure.
|
8. |
Remove the clips securing the hoses to the heat exchanger.
|
9. |
Remove the toggle clips on the side of the heat exchanger, pull down the pipes and lift out the heat exchanger.
|
Fitting |
1. |
Fit the heat exchanger.
|
2. |
Check that the O-rings are positioned correctly and that they are not damaged. Refit the pipes and secure with the clips.
|
3. |
Close the heat exchanger enclosure.
|
4. |
Refit the rear floor air ducts and secure with a cable tie. Work through the following according to descriptions in section 8:2 Interior equipment:
|
• |
Refit the centre console.
|
• |
Refit the switches for the window lifts.
|
• |
Refit the rear part of the centre console.
|
• |
Refit the rear part of the air vent and the cover.
|
• |
Refit the rear ashtray.
|
• |
Fit the cover around the ignition.
|
• |
Refit the panels on both sides of the centre console.
|
• |
Refit the glove box.
|
5. |
Refit the ACC unit, see group 8 “ACC”.
|
6. |
Refit the coolant hoses on the heat exchanger and secure with hose clips.
|
7. |
Fill coolant.
|