SAAB WIS ONLINE

Compressor oil and hoses

Compressor oil and hoses


In the A/C system, PAG oil is used ( p oly a lcylene g lycol), which is a fully synthetic glycol-type oil. PAG oil is very hygroscopic, that is, it readily absorbs moisture from the air, much the same as brake fluid. The water is chemically bound in the oil and cannot be removed by vacuum pumping. Therefore, it is very important that the oil is stored in closed containers and that it is not exposed to air other than for short periods of time. The oil is supplied in 20 ml tubes to minimise the risk of left-over oil being stored and used the next time. If the connections in the A/C system are opened, they must be plugged immediately to prevent moisture from entering the system. Special plugs for this purpose can be ordered.

Hoses, pipes and O-rings

The pipes and hoses in the A/C system must pass very stringent requirements with respect to tolerance to heat and pressure. They must also pass requirements for sealing characteristics against leaks and, for hoses, diffusion. Diffusion indicates when refrigerant leaks out through the material. Therefore, use only pipes and hoses specially manufactured for the A/C system.

In order to meet these requirements, the hoses have an inside made of butyl rubber and an outside of EPDM-rubber. The hoses are also provided with heat protection on exposed sections.

The O-rings are manufactured of a special hydrated nitril rubber. They must be lubricated using synthetic vaseline before being mounted in the A/C system. Always use new O-rings when installing A/C system components.