Acceptance inspection of a new car
Acceptance inspection of a new car |
Acceptance inspection of a new car is mandatory for all Saab cars. See Policies and Procedures (P and P).
Perform the checks and confirm these with your signature on the report. Report, see Acceptance inspection form .
Acceptance inspection |
A new car must be inspected as soon as possible after it has been accepted. The person responsible for acceptance must ensure that defects and deficiencies, etc. are reported in accordance with applicable procedures (see P and P).
1. |
Check that the specification of the car coincides with the order form. This also applies to optional equipment.
|
2. |
Check that the spare wheel, tools and other equipment supplied with the car are present.
|
3. |
Check the condition of the battery, see
Battery Check
.
|
5. |
Inspect the car internally and externally for damage.
|
6. |
Make a note of and report any damage and other observations.
|
Measures to take if the car is to be put in storage |
1. |
Check the tyre pressure and adjust to 3.5 bar (50 psi) if necessary.
|
2. |
If the car is stored in ambient temperatures exceeding +20°C, fill the fuel tank to 2/3 full. Otherwise, there is a risk of the fuel pump malfunctioning due to oxidation.
|
Additional measures if the car is to be stored outdoors |
1. |
Check the level of coolant and the antifreeze. The coolant should be able to withstand at least -30°C (-22°F). It will then also provide maximum corrosion protection. In certain climates, it is necessary for the coolant to withstand even lower temperatures. If necessary, top up with a 1:1 mixture of Saab Original Antifreeze and water.
|
2. |
If the car's RAPGARD paint protection has been removed, the car must be stored under cover.
|
3. |
Drive the car to the storage car park, applying the brakes briefly and repeatedly so that the brake discs will be clean and dry.
|
4. |
Open the bonnet.
|
5. |
Check the protective plastic on the seats and adjust if necessary.
|
6. |
Make sure that: The handbrake is released and in the off position. Reverse gear is engaged (manual gearbox). The selector lever is in position P (automatic transmission). All windows, doors and boot lid are properly closed.
|
7. |
Lock the car.
|
8. |
Disconnect the negative cable from the battery or remove the battery for charging. Close the bonnet.
|