Replacement of balancer-shaft bearings
|
Replacement of balancer-shaft bearings
|
1.
|
Remove the blanking-off washer.
|
3.
|
Carefully remove the bearing by slowly tightening the nut.
|
1.
|
Clean the bearing surface in the cylinder block.
|
3.
|
Insert the fitting tool from the flywheel end and connect the pull rod with nut.
|
4.
|
Tighten the nut until the marking on the tool is aligned with the edge of the hole for the blanking-off washer. The bearing is now in the correct position.
|
5.
|
Dismantle and remove the tool.
|
6.
|
Make sure the oilway is open.
|
7.
|
Fit a new blanking-off washer.
|