SAAB WIS ONLINE

Fuel pump, auxiliary heater

Fuel pump, auxiliary heater

Warning

Removing and fitting the fuel filter involves work on the car's fuel system. The following points must therefore be considered in connection with the work:



• Make provision for good ventilation! If approved ventilation for extracting fuel fumes is available then it must be used.

• Use protective gloves! Prolonged contact with fuel may irritate the skin.

• Keep a class BE fire extinguisher close at hand! Watch out for sparks, e.g. in connection with breaking electric circuits, short-circuits, etc.

• Smoking is absolutely forbidden.


To remove



1. Raise the car and place a receptacle under the fuel filter container.

2. Remove the protective cover in front of the fuel filter.

3. Remove the fuel pump.


4. Unplug the connector and disconnect the fuel lines on the pump.


To fit



1. Change the rubber mounting.

2. Plug in the connector and connect the fuel lines to the pump.

3. Fit the fuel pump.

4. Fit the protective cover, connect the exhaust to the engine and auxiliary heater exhaust pipe and lower the car.


5. Start the engine and start the auxiliary heater with the diagnostic tool. Check the function of the heater.