SAAB WIS ONLINE

P1110

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE.

P1110


Charge Air Bypass Valve. Performance Problems.


Fault symptoms


CHECK ENGINE.


On-Board Diagnostics

Type of diagnosis:


- Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.


Enable criteria:


- General conditions for this trouble code: When starting the engine, the atmospheric pressure must exceed 78 kPa and the engine coolant and intake air temperatures must exceed -7C.

- Main relay voltage exceeding 10V. Engine speed above 3500 rpm. Intake pressure drops rapidly more than 3 kPa, after which the accelerator pedal is fully released. Charge air pressure exceeding 120 kPa. Bypass valve solenoid deactivated.


Fault criteria:


- Charge air pressure pulsating at 14-18 Hz with amplitude exceeding 3 kPa. Criteria must be fulfilled on two separate occasions within 600 s during the same driving cycle.


Dependents:


- P0106, P0107, P0108, P1105, P1106, P1107, P1108, P1530, P1531, P1532, P1631, P1632 and P1633.


System reaction to a fault:


- None.


OK report:


- Enable criteria fulfilled and amplitude below 1 kPa. Criteria must be fulfilled on three consecutive occasions during the same driving cycle.


Fault handling: (For more information, see .)


- Type III.


Diagnostic help

Fault diagnosis concerns a fault in connecting control hoses, in the solenoid valve or the bypass valve.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Activate output for bypass solenoid.


For more information, see .