Control module power supply
| Control module power supply |
| +30 |
The main relay, fuel pump relay and fuse 17 are supplied with +30 from maxi fuse 2. Control module pin 23 is supplied from fuse 17.
The control module uses +30 for its memory.
| +15 |
Control module pin 43 is supplied with +15 from fuse 27. When +15 is applied to pin 43, the control module will be activated.
| Diagnostics |
If +30 or +15 is missing, the engine will not start and the system cannot be contacted using the diagnostic tool.
| Main relay |
When the ignition is in position ON, the main relay will operate.
Control module pin 1 is supplied from main relay pin 87 via fuse 14. This connection is used internally to feed the throttle motor.
| Diagnostics |
| • |
If the supply from the main relay to the control module is missing, diagnostic trouble code P1640 will be generated, the throttle will close and the engine will stop.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
