Speed, wire from ABS
| Speed, wire from ABS |
The ABS control module sends a speed signal to pin 64 on the Trionic T7 control module. The signal is a square wave that varies between 0 V and B+ 29 times per wheel revolution. This speed signal is used to:
| • |
on manual gearboxes, determine which gear is currently being used. This allows torque limitation in gears R and 1 and activation of the fuel shut-off in gears 2, 3, 4 and 5.
|
|
| • |
activate speed limitation, which is achieved by limiting the maximum air mass/combustion at 250 km/h.
|
|
| • |
prevent adaptation of idle speed control when the car is moving.
|
|
| Diagnostics |
| • |
If the speed signal is missing, diagnostic trouble code P0502 will be generated.
|
|
| • |
Speed (bus from MIU) used as substitute value.
|
|
System reaction to a fault
Cruise control blocked.This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
