SAAB WIS ONLINE

Brake pads, front wheel

Brake pads, front wheel

To check

It is not possible to determine by the length of pedal travel whether the brake pads are worn because the foot brake is self-adjusting. It is therefore essential to remove the wheels and check the thickness of the friction material at the intervals specified in the service programme. On these occasions, the brake pads must be changed if the friction material is less than 5 mm (0.2 in) thick.

The pads are also fitted with an acoustic wear warning device that can be heard when the thickness is less than 3 mm (0.12 in). The pads must be changed when the acoustic warning is heard.

To remove



1. Raise the car and remove the wheels.

2. Press the brake piston back, using a pair of slip-joint pliers.

3. Remove the clip from the brake caliper.

4. Remove the dust caps from the guide pins and then remove the guide pins.


5. Lift off the brake caliper from the brake disc and suspend it from the suspension strut with a cable tie.

6. Remove the brake pads. Clean inside the brake caliper with a soft metal brush and check the dust guards


To fit



1. Fit the new brake pads in the brake caliper.

• The outer brake pads are equipped with acoustic wear warning devices that must be face down.

• The inboard brake pads must be fitted with the arrows pointing in the direction of rotation of the brake disc when the car is driven in a forward direction.

2. Fit the brake caliper, clean the guide pins and tighten them using a torque wrench.

Tightening torque 28 Nm (21 lbf ft)

3. Fit the dust caps and the clip.

4. Fit the wheel, see Wheels.

Tightening torque 110 Nm (81 lbf ft)

5. Lower the car and depress the brake pedal to press out the brake pistons. Adjust the brake fluid level.