SAAB WIS ONLINE

Track-rod ends

Track-rod ends

To remove



1. Slightly loosen the clamp bolt.

2. Slightly loosen the nut.

3. Use puller 89 96 696 to press out the track-rod end.

4. Remove the nut.

5. Measure the length of thread on the adjuster screw.

6. Unscrew the track-rod end (use an adjustable spanner to steady the track rod).


To fit



1. Screw on the track-rod end to the correct position on the adjusting screw thread.

Important

Before tightening the clamp bolt, the track-rod end must be at the correct angle, that is 90 to the MacPherson strut.


2. Fit the track-rod end to the steering swivel member and tighten it.

Tightening torque: 60 Nm (44 lbf ft).

3. Tighten the clamp bolt.

Tightening torque: 22 Nm (16 lbf ft).

4. Check the toe-in and adjust as necessary. See .