SAAB WIS ONLINE

Part of side panel, 3D

Part of side panel, 3D

If the roof is undamaged, the side panel can be cut and joined further down the C-pillar. Damage to the paintwork on the roof can be avoided when the new side panel is welded on.

Important

The C-pillar must only be cut as described below. Otherwise, there is a risk of damaging the reinforcement inside the C-pillar.



1. Position the car in an aligning bench and cross-measure if necessary.

2. Cut the side panel as illustrated. Do not damage the metal underneath. The C-pillar must be cut 40 mm above the ball joint to which the gas springs are mounted.


3. Drill out the spot-welds.


4. Drill out the spot-welds.


5. Drill out the spot-welds.


6. Tap loose the side panel and align deformed or damaged panels.

7. Cut the spare part so that it overlaps the joint by approximately three centimetres.

8. Drill holes for plug-welding in the spare part.

9. Fit the spare part and fit bolts through the window frame. Fixate the spare part with a couple of welding clamps.

10. Cut through the spare part and body at the same time so that the joint can be welded edge-to-edge.

11. Remove the spare part and grind clean the surfaces to be welded on the body and the spare part.

12. Apply welding primer on the surfaces to be spot-welded. Use Teroson Zinkspray.

13. Fit the spare part and fixate with a couple of welding clamps.

14. Spot-weld the spare part.


15. Spot-weld the spare part.


16. All-weld the joints.


17. Grind the welds.

18. Remove any remaining welding primer. Welding primer reduces adhesion of paint, filler and sealant.

19. Apply primer to all ground surfaces. Use Standox 1K Primer.

20. Seal joints and sheet metal flanges with sealant. Use Terostat 1K-PUR.

21. Apply anti-corrosion agent to the interior of the side panel. Use Terotex HV 400 or Mercasol 1.