Lock cylinder, front door
|
|
Lock cylinder, front door
|
|
2.
|
Remove the microswitch by pulling of the clip and lift the microswitch from its groove.
|
|
3.
|
Remove the circlip securing the lock mounting to the lock cylinder with circlip pliers.
|
|
4.
|
Lift off the lock mounting. Make sure that the roller remains in the lock mounting.
|
|
5.
|
When the lock mounting is removed, a roller is laid open. Lift out the roller and keep it in a safe place. Remove the door handle gasket.
|
|
6.
|
Use a screwdriver and pull out an end of the circlip which locks the lock cylinder to the handle. Select the end pointing towards the end of the handle, closest to the cylinder. When the end of the circlip is visible in the opening (drain hole), bend it out so that it can be gripped with pliers. Pull out the circlip, without scratching the handle, and trash the circlip.
|
|
7.
|
Press out the lock cylinder and retain the two remaining rollers that are now laid open.
|
|
1.
|
Fit a new circlip in the groove on the cylinder.
|
Note
|
|
Do not refit a used circlip. Also make sure that the rollers are positioned correctly, otherwise the cylinder must be removed again.
|
|
|
2.
|
Fit two rollers in position on the cylinder. Grease the lock cylinder and press it into the handle. The circlip must be fitted in its previous groove with the opening facing the drain hole.
|
|
3.
|
Fit the third roller in position.
|
|
4.
|
Make sure that the roller is positioned correctly in the lock mounting. Fit the lock mounting.
|
|
5.
|
Fit a new circlip on the lock mounting and fit the door handle gasket.
|
|
6.
|
Fit the microswitch and fasten with the clip, the flat part of the clip facing up.
|
