SAAB WIS ONLINE

Replacement of upper door seal, front

Replacement of upper door seal, front

Replacement

There are two different procedures, A and B, depending on the model year and VIN.

A Weather seal fastened with butyl tape in B-pillar trim radius



1. Open the door and remove the scuff plate and door weather seal.


2. Remove any remains of the butyl tape from the B-pillar trim.

3. Fit the new weather seal. Start in the top rear corner with the colour marking in the centre of the radius.

Fit the rest of the seal.

4. Wash off the colour marking with water.


B Weather seal fastened with plastic plug in B-pillar trim radius


1. Open the door and remove the scuff plate.

2. Remove the plastic plug securing the door weather seal to the top rear corner of the B-pillar trim and remove the door weather seal.


3. Position the new weather seal with the colour marking towards the roof just where the radius starts.


4. Make a 5 mm hole, 8 mm in from the edge of the lip, to correspond with the hole in the B-pillar trim.


5. Fit the plastic plug.

6. Fit the rest of the seal.

7. Wash off the colour marking with water.

8. Fit the sill scuff plate.