Energy absorber for improved head impact protection

Energy absorber for improved head impact protection

When replacing interior equipment, special notice must be given to the absorbents used to take up the forces from possible impact with the passenger's/driver's head. These absorbents are mounted between the trim and the body and are designed depending on their location. It is essential that the absorbent and the trim are both intact and correctly fitted in the car so that the correct level of protection is attained.

See also Trim, headlining , Courtesy handle , Trim, B-pillar, 5D , Trim, B-pillar, 3D and Trim, C-pillar for instructions on changing components.

Procedure for crash repairs

The following directions apply to the repair of a car with collision damage where at least one airbag has been activated.

•	If there was a passenger in the rear seat, all the absorbents must be replaced.

•	If only front-seat passengers were involved then the front absorbers up to and including the B-pillar must be changed.

•	All the absorbents must be replaced if there is damage to the roof or pillars.

•	If in doubt, replace all the absorbents.

•	Replace any trim or absorbents that have visible damage.

The following directions must be followed when repairing interior equipment that includes energy absorbers.

•	Roof pillars and headlining should only be repaired at an authorized service workshop.

•	All repairs must be carried out in accordance with specified instructions and with great care.

•	Components included in the system must not be dismantled or repaired. They must be handled with care

•	A defective component must not be fitted.