Lubricant
| Lubricant |
| Lubrication in conjunction with service work |
|
Pos.
|
Lubrication point
|
Lubricant
|
|
1
|
Bonnet lock with locking pin and safety latch
|
Gleitmo 805, part no. 30 06 442
|
|
2
|
Battery terminals
|
Vaseline, part no. 30 06 665
|
|
3
|
Manual gearbox
|
Saab synthetic manual gearbox oil, part no. 400 108 247.
Synthetic motor oil must not be used. |
|
4
|
Automatic transmission
|
ATF Texaco Texamatic Dexron III (mineral-oil base) (7045 EU, TL 1863 US)
|
|
5
|
Outboard drive shaft CV joint
|
Molycote VN 2461C part no. 87 81 676
|
|
6
|
Inboard drive shaft CV joint
|
Shell Grease SL 0233, part no. 87 92 624
|
|
7
|
Brake system
|
Brake fluid, grade to DOT 4 specification
|
|
8
|
Brake pads against brake caliper
|
PBC copper grease, part no. (16)-30 07 457 or (16)-30 07 481
|
|
9
|
Hydraulic clutch operation
|
Brake fluid, grade to DOT 4 specification
|
|
10
|
Brake light switch
|
Vaseline, part no. 30 06 665
|
|
11
|
Door switch, interior lighting
|
Vaseline, part no. 30 06 665
|
|
12
|
Seat rails
|
Saab special chassis grease EP 2, part no. 30 09 990 (sparingly)
|
|
13
|
Boot lid lock mechanism
|
Thin penetrating oil
|
|
14
|
Door check arms and bearings in B-pillars.
Boot lid hinges |
Gleitmo 880, part no. 30 06 582
|
|
15
|
Removable towing attachment
|
Molycote 33, part no. 30 20 476
|
|
16
|
Power steering
|
Power steering fluid CHF 11S, part no. 30 32 380 - 1 litre
|
|
17
|
Gear lever housing
|
Gleitmo 980 spray, part no. 30 06 954. Leave to dry for 15 minutes and then smear with Gleitmo 750 grease, part no. 30 07 309 paste
|
|
18
|
Windscreen wiper arm joints
|
Gleitmo 805 (white grease), part no. 30 06 442 or Gleitmo 880 (spray), part no. 30 06 582
|
|
19
|
Front anti-roll bar bushings
|
Molycote 33 medium, part no. 30 20 476
|
|
20
|
Input shaft splines
|
Molycote Rapid G part no. 87 81 684
|
|
21
|
Engine oil
|
Petrol engine (with and without turbocharger):
Saab "Turbo engine oil, Synthetic Blend" SAE 5W-30 or engine oil that fulfils the requirements of API SH/SJ and ACEA A3-98 with viscosity SAE 5W-30. These should be completely or semi-synthetic. The lowest requirement for high performance engines is GM-LL-A-025 / 0W-40. At constant temperatures in tropical climates, use 10W-50 or 15W-50, which also fulfil the above requirements. We advise against the use of additional additives. Diesel engine: Saab engine oil 5W-40 for diesel or Mobil Super S 5W-40 or oil that fulfils the requirements of ACEA A3/B3, B4 with viscosity SAE 5W-40 or GM-LL-B-025 / 0W-40. |
| Lubrication to prevent seizing |
Threaded joints subjected to wide temperature fluctuations may tend to seize and will then be difficult to unscrew on the next service occasion.
Typical threaded joints of this type are:
Oxygen sensor
Retaining nuts for the exhaust manifold and turbocharger
Recommended lubricants: MOLYCOTE 1000 - 30 20 971 or NEVER SEIZE.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
