SAAB WIS ONLINE

In-storage car care

In-storage car care

In-storage car care is obligatory for all Saab cars at intervals of not more than 60 days until the car is sold. See Policies and Procedures (P and P).

Perform the inspections and confirm with your signature on the form. Form, see page .

Refer to service information and procedures when rectifying faults.

Inspection and rectification points


1. Check that the paint protector is intact. If it needs making good, the car must first be washed so that dust and dirt will not be enclosed. Inspect the paintwork, make a note of any damage and apply fresh paint protector.

Important

Paint protector hardens when exposed to UV radiation and heat. It must therefore be replaced at intervals of three to six months. Six month intervals can most probably only be applied in winter climate.

RAPGARD paint protector must only be left on the car for a maximum of 3 months and then removed. For removing, see section “Final dismantling and finishing measures

When applying new paint protector, refer to the section “Applying new paint protector”.


2. Fill the fuel tank to at least 2/3 full to prevent the fuel pump from running dry and oxidation causing malfunctioning of the fuel pump.

3. Check the battery voltage.


• The voltage should be checked within 6 hours of the engine being turned off or the battery being charged with a battery charger. Depending on the voltage reading, the following measures must be taken.

Voltage reading

Measure



Above 12.4 V

OK



Between 12.0 V and 12.4 V

Charge



Below 12.0 V

Change





• Check the level of the electrolyte and top up to the normal level as necessary.

Charging

Use a battery charger that delivers a charging current of 4-8 A. The battery terminals and covers do not require removal.

Important

Do not use so called quick-chargers.


4. Check the engine oil. If the oil is thick or contains lumps, both oil and oil filter must be changed.





5. Warm up the engine until the radiator fan cuts in. At low idling speed, turn on the A/C or ACC.

6. Check the tyre pressures and adjust them if necessary to at least 3.5 bar (50 psi).


Important

If the car is parked with the tyres inflated at too low a pressure, a flat area will form on them where they rest on the ground. This gives rise to vibration and makes wheel balancing more difficult.


7. Check the level of the coolant.

8. Drive the car for at least 200 metres, applying the brakes briefly and repeatedly so that the brake discs will be clean and dry.

9. Park the car facing in the opposite direction to equalize the effect of sunlight on it.

10. Open the bonnet to cool the engine down more rapidly.

11. Check the protective plastic on the seats and adjust if necessary.

12. Make sure that: The handbrake lever is released completely. Manual gearbox, engage reverse gear. Automatic transmission, set the selector lever to the P position. All windows, doors and the boot lid are properly closed.

13. Lock the car.

14. Check the engine bay for signs of corrosion, especially the aluminium. If this is the case, treat the areas with Teroson Skyddsvax, part no. 30 15 914. Cover with a film of wax with no surplus (10-15 µm when dry). Be especially careful with aluminium surfaces.

Important

The protective wax may well be left on as engine bay protection when the car is delivered to a customer. If the customer will not accept the waxed surface, it must of course be washed off.


Warning

Bear in mind the danger of fire Make particularly sure that the temperature of the engine bay has gone down. Do not spray onto the ends of the generator.


15. Disconnect the positive cable from the battery or remove the battery for charging.

Close the bonnet.