Camshaft cover
Camshaft cover |
1. |
Remove the engine cover and detach the crankcase ventilation hose from the camshaft cover.
|
2. |
Remove the turbo delivery pipe (2 bolts under the wiring harness).
|
3. |
Remove the front wiring harness channel and cut the securing points on the rear section of the wiring harness.
|
4. |
Remove the wiring harness channel from the cylinder head and disconnect the fuel lines from the camshaft cover.
|
5. |
Remove the fastener for the fuel lines on the engine mounting.
|
6. |
Remove the camshaft cover.
|
To fit |
1. |
Clean any gasket remains from the sealing surfaces on the camshaft cover.
|
2. |
Position a new gasket on the camshaft cover. There are sleeves on the bolts on which the gasket fits.
|
3. |
Apply sealing compound 87 81 841 to the sealing surface, see illustration.
|
4. |
Position the transmission cover on the cylinder head and tighten the bolts.
Tightening torque: 8 Nm (6 lbf ft). |
5. |
Press the fuel lines back into their fastenings and fit the wiring harness channel on the cylinder head.
|
6. |
Fit the fastener on the engine mounting and refit the front wiring harness channel. Secure the wiring harness.
|
7. |
Refit the turbo delivery pipe.
|
8. |
Refit the air cleaner with mass air flow sensor and hoses. Connect the crankcase ventilation hose to the camshaft cover.
|
9. |
Refit the engine cover.
|
10. |
Restore the engine bay to its original condition.
|