Matching of pistons
Matching of pistons |
Important | ||
Pistons of different makes must not be used in the same engine. The name of the manufacturer is cast-in on the inside of the piston. |
||
Pistons are stocked as a spare part in standard and oversizes. The cylinder must be rebored when fitting oversize pistons to obtain the correct piston clearance.
When matching pistons to cylinders, a 1/2" wide feeler gauge is used. The cylinder bore must be lightly oiled and the piston fitted in the relevant cylinder without rings. The feeler gauge should be connected to a spring scale and placed between the piston and the cylinder barrel at right angles to the gudgeon pin. When the load is 8-12 N (1.8-2.7 lbf) then the mean clearance corresponds with the thickness of the feeler gauge. The test should be carried out at several levels.
Concerning piston clearance, see "Technical data".