SAAB WIS ONLINE

Check values, control module connections, DICE

Check values, control module connections, DICE




Scope

Values and directions for measuring signals and levels in DICE can be found on the following pages.

Keep in mind


Note the measuring conditions, use common sense when considering the measurement results.

The values given apply with the ignition key in the ON position unless otherwise indicated.

First check that the control module is supplied with power and that it is grounded.

Then check all the inputs and signals from other systems.

Finally, check the control module outputs. Remember that the measured values will not indicate if the switch device is functional.

If any measured value is incorrect, use the wiring diagram to diagnose which leads, connections or components that should be checked further.

Given values refer to calibrated Fluke 88/97.

The measured values %(+) and ms(+) shows the pulse of the signal respective pulse length. Test instrument with pulse quotient respective pulse width measuring capacity must be used. The sign (+) indicates positive trigger pulse, TRIG+.







>= greater than; <= less than; ~= alternating current

A pin without further comments does not have a pin connection. (LP: LOGIC PROBE P= select pulse; p= visible pulses)


Pin nr

Lead colour

Component/function

In/out

Measuring condition

Measure between

Value

See

35

BN/RD

Radiator fan low speed,

relay.

Out

Activate function with diagnostics tool.

26-35

B+



53

BN/GY

Radiator fan high speed,

relay.

Out

Activate function with diagnostics tool.

26-53

B+