Crankshaft position sensor
Crankshaft position sensor |
|
To remove |
1. |
Undo the exhaust manifold heat shield and the bypass pipe with valve.
|
2. |
Undo the screw securing the heat shield and sensor.
|
3. |
Detach the sensor and O-ring.
|
4. |
Follow the sensor connecting cable and undo the clip on the water pipe.
|
5. |
Unplug the top part of the connector for the front oxygen sensor.
|
6. |
Unplug the top part of the connector for the position sensor and then detach the connector from the holder by carefully pressing in the catches with a small screwdriver.
|
7. |
Remove the position sensor.
|
To fit |
1. |
Fit the sensor provisionally so that the cable runs along the water pipe. Change the O-ring if necessary and lubricate it with engine oil.
|
2. |
Spray the connector with Kontakt 61 (part no. 30 04 520) and mount the connector to the holder. Plug in the connectors.
|
3. |
Secure the cables with the clip. Take care not to pinch or damage the cable with the clip.
|
5. |
Fit the heat shield and bypass pipe with valve.
|
6. |
Start the engine and check for oil leaks.
|