Turbo bypass control valve
|
Turbo bypass control valve
|
1.
|
Unplug the two pin connector from the control valve.
|
2.
|
Fold up the bonnet sealing strip by the control valve mounting plate.
|
3.
|
Carefully pull out the mounting plate and unhook it from edge of the bulkhead. Lift up the unit.
|
4.
|
Mark the vacuum hoses and detach them from the valve.
|
5.
|
Drill out the pop rivets securing the control valve to the mounting plate.
|
1.
|
Fit a new valve to the mounting plate with pop rivets.
|
2.
|
Connect the vacuum hoses to the valve.
|
3.
|
Fit the mounting plate.
|
4.
|
Fit the bonnet sealing strip.
|
5.
|
Spray the two pin connector with Kontakt 61 (part no. 30 04 520) and plug it into the control valve.
|