P1300
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Market US/CA: CHECK ENGINE.
Running unevenly and misfiring.
Random Misfire Detected. Catalyst Damaging.
Fault symptoms
|
•
|
Market US/CA: CHECK ENGINE.
|
|
•
|
Running unevenly and misfiring.
|
On-Board Diagnostics
Type of diagnosis:
|
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
|
-
|
General conditions for this trouble code: Atmospheric pressure must exceed 72 kPa and the engine coolant and intake air temperature must exceed -7°C.
|
|
-
|
Engine running. Main relay voltage exceeding 10V. Ignition discharge module combustion signals registering. The number of missing combustion signals is accumulated for each cylinder every 200 engine revolutions. The total number of accepted misfires during 200 engine revolutions is specified in a load and engine speed-dependent matrix.
|
Fault criteria:
|
-
|
Number of missing combustions exceeding number of accepted misfires. More than one cylinder has misfired.
|
Dependents:
System reaction to a fault:
|
-
|
Under high engine loads, closed loop will be blocked while misfiring occurs.
|
OK report:
|
•
|
Provided fault criteria are not fulfilled during the driving cycle, the OK report will made when the ignition is turned off and before the engine stops. Two other types of OK report can also be made:
Type 1:
If a diagnostic trouble code has already been generated for the diagnosis and the same running conditions have occurred (coolant temperature above or below 71°C, engine speed ±375 rpm and load ±10%).
Type 2:
If there is no diagnostic trouble code stored for the diagnosis or the same running conditions have not occurred.
|
Fault handling:
(For more information, see
.)
Diagnostic help
If any other trouble codes have been generated, check whether fault diagnosis should be started on any of them first. Read Freeze Frame and change spark plugs.
Then make a general inspection of connectors and hoses and subsequently a thorough check of compression, ignition and fuel system.
Functions in the diagnostic tool related to the fault:
|
•
|
Diagnostic status for the diagnosis.
|
|
•
|
Multiplicative Adaptation, unit %
|
|
•
|
Additive adaptation, unit mg/c.
|
|
•
|
Purge Adaptation, unit %.
|
|
•
|
Air mass deviation from calculated, unit %.
|
|
•
|
Activating misfire counter reset.
|
|
•
|
Activating ignition triggers.
|
|
•
|
Activating injector test.
|
For information, see
.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
