Control module power supply
|
|
Control module power supply
|
The main relay, fuel pump relay and fuse 17 are supplied with +30 from maxi fuse 2. Control module pin 23 is supplied from fuse 28.
The control module uses +30 for its memory.
Control module pin 43 is supplied with +15 from fuse 17. When +15 is applied to pin 43, the control module will be activated.
|
•
|
If +30 or +15 is missing, the engine will not start and the system can not be contacted using the diagnostic tool.
|
When the ignition is in position ON, the main relay will operate.
Control module pin 1 is supplied from main relay pin 87 via fuse 26. This connection is used internally to feed the throttle motor.
|
•
|
If the supply from the main relay to the control module is missing, diagnostic trouble code P1640 will be generated, the throttle will close and the engine will stop.
|
