SAAB WIS ONLINE

Speed, wire from ABS

Speed, wire from ABS





The ABS control module sends a speed signal to pin 64 on the Trionic T7 control module. The signal is a square wave that varies between 0 V and B+ 29 times per wheel revolution. This speed signal is used to:


• prevent adaptation of idle speed control when the car is moving.

• on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.

• activate speed limitation, which is achieved by limiting the maximum air mass/combustion at 250 km/h for B235R and 240 km/h for B205L/R.




Diagnostics


• If the speed signal is missing, diagnostic trouble code P0502 will be generated.

• If the speed value is implausible, diagnostic trouble code P0501 will be generated.


System reaction to a fault


• Speed (bus from MIU) used as substitute value.

• Cruise control blocked.