SAAB WIS ONLINE

Glass breakage sensor

Glass breakage sensor

To remove


Note

The glass breakage sensor is not stocked separately as a spare part. The complete lens cover must be replaced.



1. Release the lens cover on the centre roof light.

2. Loosen the switch panel on the roof lamp by pressing it forwards and at the same time pulling the rear edge downwards.

3. Release the electrical connector from the sensor and lift off the lens cover.


To fit



1. Replace the connector. Ensure that the connector is properly seated and attached to avoid vibrations.

2. Fir the switch panel. Start with the front edge and push it forwards. Then press the rear edge upwards.

3. Fit the lens cover.