Tilt sensor
Tilt sensor |
To remove |
1. |
Remove the antenna unit by turning it clockwise. Lift the unit up and disconnect the electrical connector.
|
2. |
Remove the ignition switch cover. Start at the back as it is fastened with hooks at the front.
|
3. |
Unscrew 2 screws holding the floor console.
|
4. |
Remove the rear section of the floor console.
|
5. |
Unscrew 2 nuts holding the floor console.
|
6. |
Remove the switch. Bend at the front edge.
|
7. |
On the Cabriolet, remove the interior lighting switch.
|
8. |
Loosen the remote control receiver from the side wall of the floor console.
|
9. |
Disconnect the electrical connector from the receiver unit.
|
10. |
Lift off the floor console.
|
11. |
Lift the floor duct.
|
12. |
Remove the tilt sensor from its holder (slides off).
|
13. |
Disconnect the electrical connector from the tilt sensor.
|
To fit |
1. |
Fit the connector to the tilt sensor.
|
2. |
Fit the sensor on its holder.
|
3. |
Fit the floor duct in position.
|
4. |
Fit the floor console in position.
|
5. |
Fit the switch.
|
6. |
Fit the remote control receiver.
|
7. |
Fit the connector on the receiver.
|
8. |
Screw the floor console in position with the 2 screws and 2 nuts.
|
9. |
Fit the rear section of the floor console.
|
10. |
Fit the ignition switch cover.
|
11. |
Fit the antenna unit.
|