Control module
Control module |
To remove |
1. |
Undo and lift out the left-hand front seat.
|
2. |
Detach and fold away the carpet. (3D: the belt guide must be detached first.)
|
3. |
Unplug the connector to the electronic control module.
|
4. |
Unscrew 1 nut and lift away the control module.
|
To fit |
1. |
Fit the control module and screw it down.
|
2. |
Plug in the connector to the control module.
|
3. |
Replace the carpet. (3D: fit the belt guide.)
|
4. |
Refit the front seat.
|
5. |
After replacement of the TWICE control module, it must be programmed into the car.
|
Programming |
Note | ||
All keys to the car must be programmed at the same time. |
Important | ||
The transponders and remote controls that are not available during programming will be rendered unusable. |
||
1. |
Connect the diagnostic tool.
|
3. |
Hold the included transponder above the hole in the antenna unit. Turn the ignition to the ON position. Hold the transponder in the same position for a few seconds.
When the alarm indicator diode stops flashing, the transponder code has been read by TWICE. If the alarm indicator diode does not stop double flashing, repeat step 3. Adjust the position of the included transponder. |
4. |
Select body system and navigate to TWICE with the diagnostic tool. Do not press ENTER.
|
5. |
Hold the included transponder above the hole in the antenna unit.
|
6. |
Press ENTER on the diagnostic tool.
|
7. |
Select Programming.
|
8. |
Select Spare Part Programming.
|
9. |
Carry out Spare Part Programming; select the alternatives applicable to the car.
|
10. |
Once Spare Part Programming has been carried out, select “Programming transponders and remote controls”. Press ENTER. When asked “Do you wish to exit”, press NO.
|
11. |
Hold the included transponder above the hole in the antenna unit. The seat belt warning lamp should flash to indicate that the transponder code was understood by TWICE. Press OK.
|
12. |
If the seat belt warning lamp does not flash, turn the ignition to the OFF position and try again from step 3.
|
13. |
Follow the instructions in the diagnostic tool, with the following exception: The first time, the following should be done at step three in Tech 2: Refit the antenna unit. Reinsert the same key.
|
14. |
Follow the instructions in the diagnostic tool.
|
Tech 2 |
|
1. |
Once all keys have been programmed, select “Immobilisation”.
|
2. |
Carry out immobilisation programming.
|
3. |
Erase DTCs in TWICE.
|
4. |
Erase DTCs in the engine management system.
|
5. |
Scrap the included transponder.
|
6. |
Fill in the return form that comes with the spare part box and return TWICE within 40 days of the order date.
|