SAAB WIS ONLINE

Bearing race - input shaft in gearcase

Bearing race - input shaft in gearcase

To remove



1. Remove the 4 screws from the seal retainer. Keep the seal retainer, screws and shims.

2. Press out the bearing race with 87 90 800 Drift, sealing ring differential bearing and use tool 87 92 236 as a support.



To fit



1. Turn the gearcase and fit the bearing race in position using a plastic hammer.

2. Then press down the bearing race with 87 92 202 Sleeve and 87 91 188 Support, removing pinion shaft until the tool reaches the bottom of the gearcase.

3. Fit the bearing retainer with a nominal shims combination of 1.5 mm. Tighten down the bearing race alternately with the bearing retainer.

Tightening torque 38 Nm (28 lbf ft)