Handbrake lever
Handbrake lever |
To remove |
1. |
Raise the car.
|
2. |
Remove the return springs from the levers on the right and left sides.
|
3. |
Press out the rear locating sleeve from the holders on the right and left sides.
|
4. |
Press out the front locating sleeve from the holder on the right side.
|
5. |
Remove the cable from the levers.
|
6. |
Remove the nuts from the heat shield plate in front of the tank.
|
7. |
Remove the adjusting nut from the pull rod and move aside the cable adjuster. Measure the thread length on the pull rod.
|
8. |
Remove the rubber gaiter.
|
9. |
Lower the car and remove the driver's seat and the centre console, see Body, Interior equipment, Adjustment and replacement
![]() |
10. |
Remove the two retaining screws for the handbrake lever as well as the cable terminal for the handbrake switch. Lift out the handbrake.
![]() |
To fit |
![](/images/9-3-9400/img-d5/d551r036.jpg)
1. |
Fit the cable terminal to the handbrake switch.
|
2. |
Fit the handbrake lever and tighten the two retaining screws.
|
3. |
Fit the centre console and the driver's seat, see Body, Interior equipment, Adjustment and replacement
![]() |
4. |
Raise the car and fit the rubber gaiter as well as the pull rod.
![]() Fit the cable adjuster to the pull rod, and fit the adjusting nut to the measured thread length. |
5. |
Fit the cable to the levers.
|
6. |
Fit the front locating sleeve to the holder on the right side.
|
7. |
Fit the rear locating sleeves.
|
8. |
Fit the returns springs for the levers.
|
9. |
Fit the heat shield plate.
|
10. |
Lower the car and check the handbrake function.
|