Stone damage tape, 3D

/ 9-3 (9400) / 2000 / 8. Body / Exterior / Adjustment/replacement / Stone damage tape, 3D

Removing

1.	Remove the plastic nuts that hold the rear outer sill scuff plate. Pull it rearwards and lift away the sill scuff plate.

2.	Press out the two upper clips of the stone damage protection from the inside of the wheel housing.

3.	Remove the lower clip by pulling and remove the stone damage protection.

Fitting

1.	Fit the stone damage protection and press in the lower clip.

2.	Press in the two upper clips.

3.	Refit the sill scuff plate by pushing it on to the guides in the top, then press the plastic nuts into place.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.