SAAB WIS ONLINE

Oil filter, ch no 12020001-

Oil filter, ch no 12020001-

To remove


1. Remove the engine cover.

2. Release the EGR valve connector


3. Take off the lid on the oil filter housing and remove the oil filter.

Note

A 36 mm socket is required.



To fit


1. Change O-rings.


2. Fit a new oil filter and tighten the lid on the oil filter housing.

Tightening torque: 25.5 Nm (19 lbf ft).

3. Connect the EGR valve connector.

4. Top up engine oil according to specifications, see Lubricating system .

5. Start the engine and let it run until the oil pressure warning lamp goes out. Stop the engine and check the oil level. Top up if necessary.