Drive belt for auxiliaries
Drive belt for auxiliaries |
To remove |
1. |
Detach the air cleaner and put it to one side.
|
2. |
Relieve the tension on the belt tensioner with a jointed handle and insert a 3.5 mm drill in the hole.
|
3. |
Remove the drive belt from the pulleys.
|
4. |
Raise the car, remove the front right wheel and the cover. Remove the drive belt.
|
To fit |
1. |
Fit the drive belt and check its position on all the belt pulleys.
|
2. |
Fit the cover and wheel.
Tightening torques: Wheels: 110 Nm (84 lbf ft) |
3. |
Lower the car. Relieve the pressure on the belt tensioner with a ratchet handle extension and remove the drill.
|
4. |
Fit the air cleaner.
|
5. |
Start the engine and run it at idling speed for a while. Switch off the engine and check that the belt is positioned correctly.
|