SAAB WIS ONLINE

Rear engine mounting, man.

Rear engine mounting, man.

To remove


1. Open the bonnet.

2. Put protection on the wings.

3. Remove the upper engine cover.


4. Remove the bolts retaining the intake manifold.

5. Fit 83 94 850 Lifting beam .

6. Take up the weight of the engine.

7. Raise the car.

8. Dismantle the selector lever link and remove the mounting pad nut.


9. Undo and remove the bracket from the gearbox.

10. Undo and remove the engine mounting pad from the subframe.


To fit


1. Position the mounting pad in the subframe and thread on the nuts.


2. Position the bracket and tighten the bolts to torque.

Tightening torque: 85 Nm (65 lbf ft)

3. Thread on the nut securing the mounting pad to the bracket and fit the selector lever link.

4. Tighten the nuts securing the mounting pad to the subframe.

Tightening torque: 85 Nm (65 lbf ft)

5. Lower the car and take up the weight of the engine.

6. Remove the lifting sling.


7. Tighten the nut securing the mounting pad to the bracket.

Tightening torque: 45 Nm (35 lbf ft)

8. Fit the protective cap over the intake.

9. Remove the wing protection and shut the bonnet.