Cleaning, charge air cooler
| Cleaning, charge air cooler |
| 1. |
Stand the cooler on edge with the lowest connection at bottom and allow the oil, if any, to run out.
|
|
| 2. |
Lay the cooler flat and pour in
30 02 482 Remover
, or the equivalent. Move the cooler sideways and angled in different directions so that the cleaning fluid reaches all parts of the interior. Drain the cooler and repeat the procedure.
|
|||||||||
Warning
| 3. |
Drain the cooler, positioning it with the lowest connection at bottom.
|
|
| 4. |
Place the cooler in an inclined position and rinse it out with hot water. Rinse it alternately from the right and left connections until the water no longer contains any traces of oil.
|
|
| 5. |
Stand the cooler on edge after rinsing it and allow the water to run out.
|
|
| 6. |
Finally, blow the cooler dry carefully with compressed air to get rid of any remaining water.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
