SAAB WIS ONLINE

P0507

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE. Fast idling speed.

P0507


Idle Speed Control. Idling Speed too High.





Fault symptoms


CHECK ENGINE.

Fast idling speed.


On-Board Diagnostics

Type of diagnosis:


- Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.


Enable criteria:


- General condition for this diagnostic trouble code: Atmospheric pressure must exceed 72 kPa as well as coolant and intake air temperature must exceed -7°C.

- Engine running. Car stationary. Accelerator pedal fully released. Idle speed control requesting smallest possible air mass per combustion.


Fault criteria:


- Engine speed more than 200 rpm above the requested idling speed for 10 sec.


Dependents:


- P0501, P0502, P1230, P1530, P1531 and P1532.


System reaction to a fault:


- None.


OK report:


- Diagnosis performed once and fault criteria not fulfilled.


Fault handling: (For more information, see .)


- Type III.


Diagnostic help

If other codes have been generated, check whether fault diagnosis should start with any of them. Then, check whether the throttle is in limp-home mode and finally check whether there is an air leak after the throttle.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Idle speed control, unit ON/OFF.

Idling speed difference, unit rpm.


For information, see .