Antenna/dummy antenna, fixed (3D/5D)
Antenna/dummy antenna, fixed (3D/5D) |
Note | ||
Cars from model year 2001 and VIN 12046130 without preparation for handsfree have a dummy antenna mounted on the roof. For more information, see Telephone system . |
To remove |
If unsure as to whether or not the car is prepared for handsfree, perform a check. Use a torch to shine through the microphone mesh. On cars prepared for handsfree, a black microphone is clearly seen behind the mesh. On cars not prepared for handsfree, there is empty space behind the mesh.
1. |
Remove the parcel shelf.
|
2. |
Fold the rear seat backrest forward.
|
3. |
Remove the speaker grilles in the parcel shelf on the RH and LH sides.
|
4. |
Remove the C-pillar trim on the RH and LH sides.
|
5. |
Remove the rear courtesy handles on the RH and LH sides.
|
6. |
Remove the two plastic clips and lower the headlining.
|
7. |
Disconnect any wires connected to the antenna.
|
8. |
Loosen the nut at the antenna base and remove the antenna.
|
To fit |
1. |
Fit the antenna and tighten the nut.
Tightening torque: 3.0 Nm (2.2 lbf ft). |
2. |
Connect any wires to the antenna.
|
3. |
Lift the headlining and fasten with the plastic clips.
|
4. |
Fit the rear courtesy handles on the RH and LH sides.
|
5. |
Fit the C-pillar trim on the RH and LH sides.
|
6. |
Fit the speaker grilles in the parcel shelf on the RH and LH sides.
|
7. |
Raise the rear seat backrest.
|
8. |
Fit the parcel shelf.
|