Wiring harness, seatbelt tensioners
|
|
Wiring harness, seatbelt tensioners
|
Warning
|
|
The joining of SRS cables is forbidden.
|
|
Joining can cause functional disorders that make the system unusable and can lead to personal injuries
|
|
|
|
|
|
|
Note
|
|
If the car is fitted with a radio other than a Saab original radio, check that the customer has the radio code before you begin work.
|
|
1.
|
Disconnect the negative lead of the battery.
|
|
2.
|
Remove the seat on the side where the wiring harness is to be replaced.
|
|
3.
|
Remove the floor console.
|
|
4.
|
Remove the front door scuff plate on the side where the wiring harness is to be replaced.
|
|
5.
|
Remove the cover on the B-pillar where the wiring harness is to be replaced.
|
|
6.
|
Bend aside the mats at the door sill and seat member.
|
|
7.
|
Unplug the connector of the seatbelt tensioners.
|
|
8.
|
Connect the spare parts harness to the seatbelt tensioners.
|
|
9.
|
Place the spare parts harness along the standard wiring harness via the door sill and the seat member to the floor console.
|
|
10.
|
Use a cable tie to attach the spare parts harness to the B-pillar so that it does not get caught.
|
|
11.
|
Unplug the 10-pin connector in front of the airbag control module.
Left-hand side:
|
|
12.
|
Prise out the red wire from pin1 and the yellow wire from pin 2 in the connector.
|
|
13.
|
Prise in the spare parts harness' red wire in pin 1 and yellow wire in pin 2.
|
|
14.
|
Put the connector back together.
|
|
15.
|
Continue with step 19.
Right-hand side:
|
|
16.
|
Prise out the red/yellow wire from pin 3 and the red/blue wire from pin 4.
|
|
17.
|
Prise in the spare parts harness' red/yellow wire in pin 3 and red/blue wire in pin 4.
|
|
18.
|
Put the connector back together.
|
|
19.
|
Use tape to secure the spare parts harness to the car's standard harness.
|
|
20.
|
Isolate all removed pins with tape and tape them up against the wiring harness so that they do not cause rattles.
|
|
23.
|
Fit the B-pillar cover.
|
|
24.
|
Fit the floor console.
|
|
26.
|
Connect the battery's negative lead.
|
|
27.
|
Start the engine and check to make sure the airbag lamp does not light.
|
|
28.
|
Erase all DTCs in SRS.
|
|
29.
|
Set the clock and program the radio code if applicable.
|
